66mm Flat Silicone Octagonal Small Coaster Mould

66mm Flat Silicone Octagonal Small Coaster Mould

£4.00
Stock Status: In Stock
make fridge magnets!
Facebook
Instagram
Youtube
Twitter
Pinterest
You will earn 4 points with this purchase
Information
This flat octagonal mould has a smooth interior and can be used to make a decoration base, block, fridge magnet, hanging decoration and more. Use it with epoxy resin or with Sculpt & Cast for different finishes.
  • Dimensions: 66mm x 10mm depth.
  • This mould takes approximately 50ml of resin to fill. 

If you're using these moulds to make coasters, we recommend that you add a 3mm thick clear layer of Heat-Resistant resin first in your mould. Let it set and then add more resin with colour, ink, glitter, flowers etc. Once turned out, what was the bottom will be the top and heat-resistant up to 90oC! Remember that our Heat-Resistant resin needs between 14-21 days to achieve full cure, so don't place a hot cup on it too early.

If using to make a Jesmonite coaster, remember to seal the coaster before use with our Protect-It sealant to make it less porous.

Our silicone moulds can be re-used time and again providing they are looked after well. Keep it in the bag it comes to you in, don't use a flame near the mould (use a craft heat gun instead) and be careful when de-moulding - try not to scratch the mould with long nails or bend it out of shape too much. 

If your casting comes out dull it could be that the mould has come to the end of its life (or that the mould doesn't have a shiny interior surface). You can keep using moulds that are past their best - it just takes a little more effort. Add a thin layer of resin to the casting or use polish and a cloth to bring up the shine.
Specifications
  • Product Code:
    SM.002.027
  • Shape:
    Octagon
  • Size:
    73mm x 12mm depth
  • Type:
    Coaster
c