Varying in size, these Geode Agate Coaster Moulds let you make your resin look like slices from a real geode. Use our alcohol inks to create intricate petri designs that will leave people in awe! Use a dirty pour technique combined with silicone to create a hypnotic pattern.
- Style A: 120mm x 96mm x 7mm (takes approx 65ml of resin to fill)
- Style B: 120mm x 88mm x 7mm (takes approx 60ml of resin to fill)
- Style C: 130mm x 107mm x 7mm (takes approx 80ml of resin to fill)
- Style D: 120mm x 115mm x 7mm (takes approx 80ml of resin to fill)
- Style E: 125mm x 100mm x 7mm (takes approx 70ml of resin to fill)
- All measurements are taken at widest points
If you're using these moulds to make coasters, we recommend that you add a 3mm thick clear layer of Heat-Resistant resin first in your mould. Let it set and then add more resin with colour, ink, glitter, flowers etc. Once turned out, what was the bottom will be the top and heat-resistant up to 90oC! Remember that our Heat-Resistant resin needs between 14-21 days to achieve full cure, so don't place a hot cup on it too early.
Our silicone moulds can be re-used time and again providing they are looked after well. Keep it in the bag it comes to you in, don't use a flame near the mould (use a craft heat gun instead) and be careful when de-moulding - try not to scratch the mould with long nails or bend it out of shape too much.
If using to make a Jesmonite coaster, remember to seal the coaster before use with our Protect-It sealant to make it less porous.
If your casting comes out dull it could be that the mould has come to the end of its life (or that the mould doesn't have a shiny interior surface). You can keep using moulds that are past their best - it just takes a little more effort. Add a thin layer of resin to the casting or use polish and a cloth to bring up the shine.