Give your coasters a lift with a raised edge! These Contemporary Edged Coaster Moulds are perfect for catching all those little coffee cup spills. Use as traditional coasters, add precious family snaps and make into hanging wall art or tree decorations, or use as bedside trinket dishes to hold your engagement and wedding rings. Finish with our rubber coaster feet.
- Small Round: 80mm diameter with a 10mm raised edge (approx 90ml of resin or 150g of JESMONITE to fill)
- Large Round: 100mm diameter with a 15mm raised edge (approx 120ml of resin or 200g of JESMONITE to fill)
- Hexagon:100mm across from flat edge to flat edge with a 15mm raised edge (approx 120ml of resin of 200g of JESMONITE to fill)
- Square:100mm across with a 15mm raised edge (approx 120ml of resin of 200g of JESMONITE to fill)
If you're using these moulds to make coasters, we recommend that you fill your edges and then add a 3mm thick clear layer of Heat-Resistant resin first in your mould. Let it set and then add more resin with colour, ink, glitter, flowers etc. Once turned out, what was the bottom will be the top and heat-resistant up to 90oC! Remember that our Heat-Resistant resin needs 21 days to achieve full cure, so don't place a hot cup on it too early.
If using to make a JESMONITE coaster, remember to seal the coaster before use with Protect-it sealant to make it less porous.
How to look after your new mould: top tips from the Resin8 team
Our silicone moulds can be used multiple times - to get the very best resin results it is important to care for them perfectly. Keep your mould in the bag it comes to you in and store carefully. Moulds do not like to be stacked or kept contained in a box with other items, this will result in the mould losing its shape. Moulds that are more complex to demould from will not last as long as straightforward, plain moulds.
It is best to use a heat tool such as an embossing craft gun to rid bubbles from your creations, naked flames can damage the outer edges of your mould. Take extra care when de-moulding your creation, pay special attention to not scratch the interior of your mould with long fingernails.
Any residue left in your mould once you have finished using it can be brushed out with a soft bristled brush such as a watercolour paint brush. Do not use sticky tape to de-tack dust, fluff or glitters - doing this will remove the interior shine within your mould.
If your casting comes out dull it could be that the mould has come to the end of its life (or that the mould doesn't have a shiny interior surface). You can keep using moulds that are past their best - it just takes a little more effort. Add a thin layer of resin to the casting or use polish and a cloth to bring up the shine.
You might like to consider using moulds that have past their best for another exciting craft. How about exploring the wonderful world of JESMONITE? Resin-tired moulds make excellent moulds for working with JESMONITE. You can find more about this wonderful composite here.
Should you need a little more guidance, our FAQs provide lots of helpful information, as do our YouTube videos. You may also like to join our friendly facebook group for help from our super customers.