Kawaii Star Silicone Shaker Mould

Kawaii Star Silicone Shaker Mould

Stock Status: In Stock
WAS £6.25
You will earn 4 points with this purchase
This two part puffy Star Silicone Shaker Mould allows you to make gorgeous shaker charms from epoxy resin. Cast them, fill them and dangle them from a mobile phone, keyring or even hair bobble! This mould can be used over and over again if stored carefully, away from dust and cleaned after each use. However, as with all silicone moulds, the constant de-moulding process will weaken the silicone and it will lose its shine over time.

For instructions on how to make a resin shaker charm just google "HOW TO MAKE A RESIN SHAKER CHARM". It's simple - you make two identical halves, stick them together with araldite crystal clear glue, fill the voide with glitter, sequins, etc, then seal the small hole with a fitting and more glue. It is also possible to fill the charm with water as well as glitter, a bit like a snowglobe!

This mould makes a 49mm wide star shaker, with a rough depth of 12 to 14mm. It takes approximately 20 ml of resin to make both halves of the star. 

Our silicone moulds can be re-used time and again providing they are looked after well. Keep it in the bag it comes to you in, don't use a flame near the mould (use a heat gun instead) and be careful when de-moulding - try not to scratch the mould with long nails or bend it out of shape too much. 

If your casting comes out dull it could be that the mould has come to the end of its life (or that the mould doesn't have a shiny interior surface). You can keep using moulds that are past their best - it just takes a little more effort. Add a thin layer of resin to the casting or use polish and a cloth to bring up the shine.
  • Product Code:
  • Shape:
    Stars & Snowflakes
  • Dimensions:
    49mm x 12-14mm depth