Trinket Tray / Walled Coaster

Trinket Tray / Walled Coaster

£8.95
Stock Status: In Stock
Choice of shapes
Facebook
Instagram
Youtube
Twitter
Pinterest
You will earn 8 points with this purchase
Information
Give your coasters a lift with a lipped edge! These Trinket Tray / Walled Coaster Moulds allow to you to make a walled coaster or bedside dish for holding jewellery. With a shiny interior, this high quality silicone mould can be used with any of our resins. If you want to use this mould to make a coaster we recommend our heat-resistant resin.

SMALL ROUND: 8cm diameter, 1cm high (at shallowest point), 1.26cm high at lowest point. Takes approximately 50ml of resin to fill.
LARGE ROUND: 10cm diameter, 1cm high (at shallowest point), 1.26cm high at lowest point. Takes approximately 65ml of resin to fill.
SQUARE: 10.2cm diameter, 1cm high (at shallowest point), 1.5cm high at lowest point. Takes approximately 100ml of resin to fill. 
HEXAGON: 10.1cm diameter, 1.2cm high (at shallowest point), 1.8cm high at lowest point. Takes approximately 100ml of resin to fill. 

Our silicone moulds can be re-used time and again providing they are looked after well. Keep them in the bag they come to you in, don't use a flame near the mould (use a heat gun instead) and be careful when de-moulding - try not to scratch the mould with long nails or bend it out of shape too much. 

If your casting comes out dull it could be that the mould has come to the end of its life (or that the mould doesn't have a shiny interior surface). You can keep using moulds that are past their best - it just takes a little more effort. Add a thin layer of resin to the casting or use polish and a cloth to bring up the shine.
Specifications
  • Product Code:
    SM.001.003
  • Shape:
    Coasters & Petris
  • Dimensions:
    80mm x 10-12.6mm depth
c